Average Reviews:
(More customer reviews)I had the typical pitman arm removal problem. I tried every trick in the book from sledge hammers, fork wedge, gear pullers, etc... I also broke 2 of the typical style pitman arm pullers. I ordered this thing and it is truly a beast. I cannot imagine this thing breaking.
It is well made. I installed it and ran my impact gun until the impact did not spin any more...at all. Then I broke out the 3ft breaker bar. I could barely move it. I then put a 6ft! cheater bar on the end of the breaker bar and kept torquing it down. The pitman arm slid right off after a few more turns.
Measurements: Your shaft will have to be less than 1.5" in diameter. The pitman arm will have to be less than 3" wide on the shaft end.
Bottom line: This thing will tackle the worst of pitman arm problems. It it doesn't then it will likely pull the splines right off the shaft. In that case you should get another box anyways.
Click Here to see more reviews about: OTC 8150 Conical Pitman Arm Puller
Click here for more information about OTC 8150 Conical Pitman Arm Puller
No comments:
Post a Comment